Note: If the wire circlip (2) has been removed, carefully install a new one as shown.
2. Tighten:
- lock washer (New)
- clutch boss nut 1: 70 Nm (7.0 m·kg)
Note: While holding the clutch boss with the clutch holding tool (2), tighten the clutch boss nut.
- Clutch holding tool: 90890-04086
3. Bend the lock washer tab along a flat side of the nut.
4. Lubricate:
- long clutch push rod
- short clutch push rod (with the recommended lubricant)
Recommended lubricant: Lithium soap base grease
5. Lubricate:
- friction plates
- clutch plates (with the recommended lubricant)
Recommended lubricant: Engine oil
6. Install:
- friction plates
- clutch plates
- long clutch push rod
- short clutch push rod
- bearing
- washer
Note: Make sure that the semicircular slot (a) in the friction plate is aligned with the mark (b) on the clutch housing.
7. Install:
- clutch pressure plate
- clutch spring plate seat
- clutch spring (1)
- clutch spring plate (2)
- clutch spring bolts (3)
Note: Tighten the clutch spring bolts in stages and in a crisscross pattern.
- Clutch spring bolt: 8 Nm (0.8 m·kg)