Checking of connections (Yamaha XVS 1100 Drag Star)

0

Check the connectors for stains, rust, moisture, etc.

1. Disconnect: Connector



2. Check: Connector

• Moisture → Dry each terminal with an air blower.
• Stains/rust → Connect and disconnect the terminals several times.

3. Check: Connector leads

• Looseness → Bend up the pin (1) and connect the terminals.

4. Connect: Connector terminals

Note: The two terminals "click" together.

5. Check: Continuity (using a pocket tester)

Note:

• If there is no continuity, clean the terminals.
• When checking the wire harness be sure to perform steps 1 to 3.
• As a quick remedy, use a contact revitalizer available at most part stores.
• Check the connector with a pocket tester as shown.

See this article in russian language

Article about repair motorcycles «Yamaha Drag Star XVS 1100» (1998-2008): «Checking of connections»: https://motoinstruction.ru/en/Yamaha/DragStar/XVS1100/owner/intro/114200 <a href="https://motoinstruction.ru/en/Yamaha/DragStar/XVS1100/owner/intro/114200">Checking of connections</a> - article about repair motorcycles «Yamaha Drag Star XVS 1100» (1998-2008) from section «Introduction to manual». [url=https://motoinstruction.ru/en/Yamaha/DragStar/XVS1100/owner/intro/114200]Checking of connections[/url] - article about repair motorcycles «Yamaha Drag Star XVS 1100» (1998-2008) from section «Introduction to manual».