![](https://motoinstruction.ru/img/yamaha/3/111871.jpg)
Order | Job/Parts to remove | Quantity | Remarks |
Rider and passenger seat | Refer to «General chassis». | ||
Fuel tank | Refer to «Fuel tank». | ||
Engine oil | Drain. Refer to «Changing the engine oil». | ||
1 | Crankshaft position sensor lead coupler | 1 | Disconnect. |
2 | Crankshaft position sensor | 1 | |
3 | O-ring | 1 | |
4 | Pickup rotor cover | 1 | |
5 | Gasket | 1 | |
6 | Cover | 1 |
1. Disconnect:
- Crankshaft position sensor lead coupler
2. Remove:
- Crankshaft position sensor
- O-ring
- Pickup coil rotor cover «1»
Note: Loosen each bolt 1/4 of a turn at a time, in stages and in a crisscross pattern.
After all of the bolts are fully loosened, remove them.
![](https://motoinstruction.ru/img/yamaha/3/111872.jpg)