1. Turn indicator
2. Lock system indicator
3. Neutral indicator N
4. High beam headlight indicator
5. Engine fault warning light
6. Oil level warning light
7. Coolant temperature warning light
8. Anti-lock braking system warning light (ABS)
(for models equipped with ABS)
9. Immobilizer system indicator
Turn indicator
When the turn signal switch is pressed left or right, the corresponding indicator will light up.
Neutral indicator «N»
This indicator lights up when the transmission is in neutral.
Headlight high beam indicator
This indicator lights up when the headlights are on high beam.
Oil level warning light
This warning light comes on when the engine oil level drops.
The electrical circuit of the warning lamp can be checked by turning the key to the ON position. The warning light will come on for a few seconds and then go off again. If the warning light does not come on or stays on and does not go off when you turn the key to the ON position, have a Yamaha dealer check the electrical circuit.
Note. Even if sufficient oil has been added, the warning light may come on when driving on a slope or during sudden acceleration or deceleration, but this is not a malfunction.
Note: This model is equipped with a self-diagnostic oil level detection device. If a problem is detected in the oil level detection circuit, the following cycle will be repeated until the problem is eliminated: the oil level warning light will flash ten times, then turn off for 2.5 seconds. If such a problem occurs, have your motorcycle inspected by an authorized Yamaha dealer.
Coolant temperature warning light
When the engine overheats, the coolant temperature warning light turns on. If the warning light comes on while driving, stop the motorcycle as soon as possible, turn off the engine and allow it to cool.
The electrical circuit of the warning light can be checked by turning the key to the ON position. The warning light will come on for a few seconds and then go off again. If the warning light does not come on or stays on and does not go off when you turn the key to the ON position, have a Yamaha dealer check the electrical circuit.
Warning! The engine should not be run if it is overheated.
Note: In models equipped with a radiator fan, when the temperature of the coolant in the radiator changes, the fan automatically turns on or off.
Note: If the engine overheats, follow the instructions on page 6-40.
| Coolant temperature | Display | Conditions | Your actions |
| Below 39°C |  | The message is displayed «Lo». | Keep moving. |
| 40-116°C |  | The current temperature is displayed. | Keep moving. |
| 117-139°C |  | The temperature indicator flashes. The warning light comes on. | Stop the motorcycle and idle the engine until the coolant temperature drops. If the temperature does not decrease, turn off the engine. |
| Above 140°C |  | The inscription is flashing «Hi». The warning light comes on. | Stop the engine and let it cool. |
Engine fault warning light
This warning light lights up continuously or flashes when there is a problem with the engine electrical circuit. If a problem occurs, have the self-diagnosis system checked by an authorized Yamaha dealer (See the explanation of the self-diagnosis device on page 3-11). The electrical circuit of the warning light can be checked by turning the key to the ON position. The warning light should come on for a few seconds and then go off again. If the warning light does not come on or stays on and does not go off when you turn the key to the ON position, have a Yamaha dealer check the electrical circuit.
Anti-lock braking system warning light (ABS) (for models equipped with ABS)
If this warning light comes on or flashes while driving, the anti-lock braking system may not operate properly. If such a problem occurs, have your motorcycle inspected by an authorized Yamaha dealer.
Warning! If the anti-lock braking system warning light comes on or flashes while you are driving, the brake system returns to normal operation. Therefore, be careful and try not to lock the wheels when braking in an emergency. If the warning light comes on or flashes while riding, have the brake system checked by an authorized Yamaha dealer as soon as possible.
The electrical circuit of the warning light can be checked by turning the key to the ON position. The warning light should come on for a few seconds and then go off again. If the warning light does not come on or stays on and does not go off when you turn the key to the ON position, have a Yamaha dealer check the electrical circuit.
Lock system indicator
The electrical circuit of the indicator can be checked by turning the key to the ON position. The indicator should light up for a few seconds and then go off again. If the indicator does not light up or remains on and does not go off when you turn the key to the ON position, have the electrical circuit checked by a Yamaha dealer.
30 seconds after turning the key to the OFF position, the indicator will begin to flash to indicate that the locking system has been activated. After 24 hours, this indicator will stop flashing, but the locking system will remain activated.
This motorcycle model is also equipped with a self-diagnosis device for the locking system. (Explanations on the self-diagnosis device can be found at p. 3-11).