![](https://motoinstruction.ru/img/honda/9/115347.jpg)
- (1) Speedometer
- (2) Odometer/trip display
- (3) Fuel level indicator
- (4) Neutral indicator
- (5) Low oil pressure indicator
- (6) Engine management system indicator PGM-FI
- (7) Turn signal indicator
- (8) Coolant temperature indicator
- (9) High beam indicator
- (10) Odometer/trip odometer selection button» and reset the readings
(Item no) Name | Purpose |
(1) Speedometer | Shows the speed of movement. Shows your speed in kilometers per hour (km/h) or miles per hour (mph) depending on the execution. |
(2) Odometer / mileage indicator display per trip | ODOMETER: Shows the total mileage. Trip mileage indicator: Shows the trip mileage. |
(3) Fuel level indicator (amber) | Lights up when the fuel level in the tank is low. When the warning light comes on, it means that the remaining fuel in the tank of a non-tilted motorcycle is approximately: 3.0-4.5 liters |
(4) Neutral indicator (green color) | Lights up when neutral is turned on |
(5) Low oil pressure indicator (Red color) | Lights up when the engine oil pressure drops below the standard value, as well as when the ignition is turned on when the engine is not running. It goes out after the engine starts, except in cases where it may flash periodically when the engine is not warmed up and idling. Attention! Operating the engine with insufficient engine oil pressure can lead to engine failure. |
(6) Engine management system indicator PGM-FI (Red color) | Lights up when there is a malfunction of the PGM-FI system (electronic fuel injection systems). It should also light up for a few seconds and then go out when the ignition is turned on and the engine switch is in the RUN position (JOB). Whenever the indicator comes on, reduce your speed and take the motorcycle to an authorized Honda dealer as soon as possible. |
(7) Turn signal indicator (green color) | Flashes when any turn signal is turned on. |
(8) Coolant temperature indicator (Red color) | Turns on when the coolant temperature rises above the set value. If the indicator comes on while driving, turn off the engine and check the coolant level in the expansion tank. Read the instructions Here and do not resume driving until the fault is corrected. Attention! Operating at temperatures above the permissible temperature may result in engine failure. |
(9) High beam indicator (Blue colour) | Lights up when the headlights are on high beam. |
(10) Button for selecting "odometer / trip mileage indicator" and resetting the readings | This button is used to reset the trip odometer to zero and switch between the odometer and trip odometer display modes (see Here). |