Warning! Check the condition of all components. Pay particular attention to those listed below.
BEARINGS, SEALS, WHEEL SPINDLE and WHEEL RIM; see 7.5.4.
Cush-drive rubber
Inspect the cush-drive rubber for damage or wear. Replace as required.
Fit the cush-drive rubber into the wheel hub.
Position the complete final drive assembly to the wheel. Rotate the rear chain sprocket manually in both directions and check cush-drive play in the hub. If you feel too much play, change the cush drive.
Cush-drive rubber
Inspect the cush-drive rubber for damage or wear. Replace as required.
Fit the cush-drive rubber into the wheel hub.
Position the complete final drive assembly to the wheel. Rotate the rear chain sprocket manually in both directions and check cush-drive play in the hub. If you feel too much play, change the cush drive.
Rear chain sprocket
Check the toothing of the front and rear chain sprockets for wear. In the event excess wear is found, replace front and rear chain sprockets and drive chain as a set; see 7.6.4 and 7.13.1.
Warning! Drive chain and front and rear chain sprockets must always be replaced as a set. Failure to do so will lead to early wear of the newly fitted components.
Tyre
Check tyre condition.