Rear wheel disassembly (Aprilia RS125/3)
- Main
- Aprilia
- RS-series
- RS 125 [3]
- Running gear and frame
- Wheels and tires
- Rear wheel disassembly
Read 1.2.1 carefully.
Remove the rear wheel; see 7.6.2.
Clean the wheel hub at both ends with a cloth.
Remove the oil seals (1-2).
Remove the right-hand bearing (3) and then the lefthand bearing (4) using a bearing extractor.
Collect the inner spacer (5).
Clean the hub bore thoroughly.
Remove the rear wheel; see 7.6.2.
Clean the wheel hub at both ends with a cloth.
Remove the oil seals (1-2).
Remove the right-hand bearing (3) and then the lefthand bearing (4) using a bearing extractor.
Warning! Inspect the bearings after each removal and replace as required.
Collect the inner spacer (5).
Clean the hub bore thoroughly.
Note. Wash all components with clean detergent.
Warning!
- Refit the bearings using a drift with the same diameter as the bearing outer ring.
- Do not tap the balls or the inner ring.
- Push the left-hand bearing (4) fully home.
See this article in russian language
This article has been reviewed: Artemy Kuzmin
Similar articles about motorcycles of other brands
Rear wheel — design description Suzuki DRZ 250 (1996-2007)Exploded view — rear wheel and cush drive Triumph Rocket III (2004-2018)
Disassembling the rear wheel Yamaha FZ1 Fazer (2006-2015)
Rear wheel — removal and installation Kawasaki ZX6R/ZX600J (2000-2002)
Rear wheel — removal and installation Honda CB 400 SF (1992-1999)
Link to this article in different formats
Comments and feedback from visitors
No comments yet, you will be the first!
- Information for owner
- Introduction to manual
- Maintenance
- Troubleshooting
- Engine and systems
- Engine repair
- Fuel system
- Cooling and lube system
- Running gear and frame
- Frame and hinged elements
- Front suspension and handlebar
- Rear suspension
- Brake system
- Wheels and tires
- Electric equipment
- Equipment and devices
- Starting and charging system