Removing and installing chain guide rail with swinging arm installed (BMW F650GS)

0

Remove the sprocket cover.

Remove the rear quick-release axle.

Remove the chain from the chainwheel and chain sprocket.

Remove the fasteners securing the chain guide rail to the swinging arm.

Pull out the guide rail between the sprocket and the main frame.

Installation is the reverse of the removal procedure: pay particular attention to the following.

Do not damage the guide rail when installing; mask with tape if necessary.

Tightening torques:

• Rear quick-release axle: 100 Nm
• Chain tensioning screws: 10 Nm

See this article in russian language

Article about repair motorcycles «BMW F-series F 650 GS» (2000-2007): «Removing and installing chain guide rail with swinging arm installed»: https://motoinstruction.ru/en/BMW/F/F650GS/engine/transm/112648 <a href="https://motoinstruction.ru/en/BMW/F/F650GS/engine/transm/112648">Removing and installing chain guide rail with swinging arm installed</a> - article about repair motorcycles «BMW F-series F 650 GS» (2000-2007) from section «Transmission». [url=https://motoinstruction.ru/en/BMW/F/F650GS/engine/transm/112648]Removing and installing chain guide rail with swinging arm installed[/url] - article about repair motorcycles «BMW F-series F 650 GS» (2000-2007) from section «Transmission».