Replacing grooved ball bearings of intermediate shaft (BMW R1150GS)

0

Caution: If the grooved ball bearings are replaced, the fully assembled length must be re-adjusted.

Pull off the grooved ball bearings with a universal puller, BMW No. 007500.

Press the output-side grooved ball bearing on to the intermediate shaft.

Check/adjust fully-assembled length (see 23.19).

Place spacing washer of calculated thickness in position and press on the input-side grooved ball bearing.

See this article in russian language

Article about repair motorcycles «BMW R-series R 1150 GS» (1999-2004): «Replacing grooved ball bearings of intermediate shaft»: https://motoinstruction.ru/en/BMW/R/R1150GS/engine/transm/111682 <a href="https://motoinstruction.ru/en/BMW/R/R1150GS/engine/transm/111682">Replacing grooved ball bearings of intermediate shaft</a> - article about repair motorcycles «BMW R-series R 1150 GS» (1999-2004) from section «Transmission». [url=https://motoinstruction.ru/en/BMW/R/R1150GS/engine/transm/111682]Replacing grooved ball bearings of intermediate shaft[/url] - article about repair motorcycles «BMW R-series R 1150 GS» (1999-2004) from section «Transmission».