Removing the throttle cable from intermediate pulley to oil pump (Aprilia RS125/3)
- Main
- Aprilia
- RS-series
- RS 125 [3]
- Running gear and frame
- Frame and hinged elements
- Removing the throttle cable fr…
Torque wrench settings:
Lift the fuel tank, see 2.9.1.
Remove the left fairing, see 7.1.2.
Loosen and remove the three screws (1) and remove oil pump cover.
Slide out the throttle cable.
Loosen and remove screw (2) from frame inner face, on vehicle left side.
(The source is located on a website Motoinstruction.ru)
Remove throttle cables pulley cover.
Slide out throttle cable from oil pump.
- Screw (2): 5 Nm (0.5 Kgm)
Lift the fuel tank, see 2.9.1.
Remove the left fairing, see 7.1.2.
Loosen and remove the three screws (1) and remove oil pump cover.
Slide out the throttle cable.
Loosen and remove screw (2) from frame inner face, on vehicle left side.
(The source is located on a website Motoinstruction.ru)
Remove throttle cables pulley cover.
Slide out throttle cable from oil pump.
Warning! Upon reassembly, adjust throttle cable tension by turning nut (3) on the oil pump.
See this article in russian language
This article has been reviewed: Artemy Kuzmin
Similar articles about motorcycles of other brands
Removing and installing throttle cable БМВ F 650 GS (2000-2007)Adjusting the throttle cable Suzuki DRZ 250 (1996-2007)
Throttle Cable Routing Triumph Tiger 800 (2010-2019)
Removing and installing water pump Kawasaki Versys 650 (2007-2025)
Adjusting the throttle cable free play Yamaha FZ1 Fazer (2006-2015)
Link to this article in different formats
Comments and feedback from visitors
No comments yet, you will be the first!
- Information for owner
- Introduction to manual
- Maintenance
- Troubleshooting
- Engine and systems
- Engine repair
- Fuel system
- Cooling and lube system
- Running gear and frame
- Frame and hinged elements
- Front suspension and handlebar
- Rear suspension
- Brake system
- Wheels and tires
- Electric equipment
- Equipment and devices
- Starting and charging system