Note. This part cannot be repaired. Replace upon failure.
Removal
Warning! To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before proceeding.
1. Remove main fuse.
2. See Figure 6-102. Disconnect VSS harness connector [65A] (1) from VSS (3) mounted on rear of engine case below starter motor assembly.
Figure 6-102. VSS: all models (XL shown): 1. VSS connector [65]; 2. Screw; 3. VSS
3. Remove screw (2). Carefully remove VSS and O-ring from engine crankcase.
Installation
| FASTENER | TORQUE VALUE | |
| VSS screw | 90-120 in·lbs | 10.2-13.6 Nm |
Note. The new VSS O-ring has a teflon coating that provides lubrication during installation. No other lubrication is needed.
1. See Figure 6-102. Carefully install VSS (3) and O-ring into engine crankcase with screw (2). Tighten to 90-120 in·lbs (10.2-13.6 Nm).
2. Attach VSS harness connector [65A] (1) to VSS.
3. Install main fuse.
4. Test ride the motorcycle.