Caution! Always check the speed/ABS sensor gap after replacement of ABS sensor, sensor ring, brake-calliper bracket, spacer sleeve, rear wheel or wheel bearing.
Lift rear wheel clear of the ground.
Remove wheel cover and chain cover.
Using a feeler gauge, measure the gap between ABS sensor (4) and sensor ring (5) at three points 120° apart.
Adjusting ABS sensor gap
If gap is greater than 1 mm (0.04 in) at one or more points.
Remove ABS sensor (4).
Remove washer (6).
If gap is less than 0.1 mm (0.004 in) at one or more points.
Slacken ABS sensor (4).
Install washer (6).
Caution! After adjusting, spin the wheel and make sure that the ABS sensor does not touch the sensor ring.
ABS sensor gap: 0.10...1.0 mm (0.004...0.04 in)
Tightening torque:
- Rear ABS sensor: 9 Nm