Sidestand
1. The sidestand is attached to a bracket on the frame. Springs anchored between them ensure the stand is held in the retracted or extended position. Support the bike on the centrestand.
2. On models with a rotary type sidestand switch (i.e. XL600V-R to X, XL650V and XRV750-P onwards) displace the sidestand switch (see Chapter 9). There is no need to disconnect its wiring connector or remove it completely, just let it hang from its wiring.
3. Unhook the stand springs. Unscrew the nut from the pivot bolt, then unscrew the bolt and remove the stand (see illustration).
![](https://motoinstruction.ru/img/honda/19/125661.jpg)
4.3. Unscrew the nut (A), then unscrew the pivot bolt (B)
4. On installation apply grease to the pivot bolt shank. Install the bolt and tighten it to the torque setting specified at the beginning of the Chapter securely, then install and tighten the nut to the specified torque (see illustration 4.3). Reconnect the springs and check that they hold the stand securely up when not in use - an accident is almost certain to occur if the stand extends while the machine is in motion.
5. Where applicable, install the sidestand switch. Check the operation of the switch (see Chapter 9).
Centrestand
Note: The centrestand is not standard equipment, but is available as an optional extra on certain models.
XRV750-L to N (1990 to 1992) models and XL600V-K to V-X (1988 to 1999) models
6. Support the motorcycle on its sidestand.
7. Disconnect the two return springs from their lug on the centrestand.
8. Straighten the split pin at the end of the centrestand pivot shaft, then pull the split pin out and remove the washer. Support the stand and withdraw its pivot shaft.
9. On installation, apply grease to the outside surface of the pivot shaft and the inside surfaces of the stand lugs and frame lugs. Fit the components in the reverse order of dismantling and fit a new split pin to secure the pivot shaft. Check that the return springs hold the stand fully retracted.
XRV750-P models onwards (1993-on)
10. Support the motorcycle on its sidestand.
11. Disconnect the two return springs from their lugs on the centrestand.
12. Each pivot lug of the stand is secured to the frame by a short pivot sleeve; straighten and remove the split pins, remove the washers and withdraw the pivot sleeves to free the stand from the frame.
13. On installation, apply grease to the outside surfaces of the pivot sleeves and the inside surfaces of the stand lugs and frame lugs. Fit the components in the reverse order of dismantling and fit new split pins to secure the pivot sleeves. Check that the return springs hold the stand fully retracted.