Removal
Drain the coolant (page 6-4).
Loosen the band screw.
Disconnect the lower radiator hose from the radiator.
Remove the bolts from the radiator bottom.
![](https://motoinstruction.ru/img/honda/9/115733.jpg)
Be careful not to damage the radiator fins while servicing the radiator and fan.
Loosen the band screw.
Disconnect the upper radiator hose from the radiator.
Remove the radiator mounting bolt and washer.
![](https://motoinstruction.ru/img/honda/9/115734.jpg)
Disconnect the fan motor switch 2P connector and remove it from the tab on the frame.
Remove the radiator.
![](https://motoinstruction.ru/img/honda/9/115735.jpg)
Disassembly
Remove the radiator cover bolts, radiator lower cover, upper cover and grill.
![](https://motoinstruction.ru/img/honda/9/115736.jpg)
Disconnect the fan motor switch connector and remove the wires from the clamps.
Remove the bolts and the ground terminal.
Remove the fan motor assembly from the radiator.
![](https://motoinstruction.ru/img/honda/9/115737.jpg)
Remove the nut and cooling fan from the motor.
![](https://motoinstruction.ru/img/honda/9/115738.jpg)
Remove the nuts and the fan motor from the shroud.
For fan motor switch information, refer to page 19-14.
![](https://motoinstruction.ru/img/honda/9/115739.jpg)
Assembly
![](https://motoinstruction.ru/img/honda/9/115740.jpg)
Install the fan motor onto the shroud with the drain hose facing down as shown, and tighten the nuts securely.
![](https://motoinstruction.ru/img/honda/9/115741.jpg)
Install the cooling fan onto the motor shaft, aligning the flat surfaces.
Install and tighten the nut securely.
![](https://motoinstruction.ru/img/honda/9/115742.jpg)
Install the fan motor assembly onto the radiator and tighten the mounting bolts with the ground terminal.
Route the wires properly, clamp the wires and connect the switch connector.
![](https://motoinstruction.ru/img/honda/9/115743.jpg)
Install the radiator grill, lower cover and upper cover. Install and tighten the radiator cover bolts to the specified torque.
Torque:
- Radiator cover bolt: 10 N·m (1.0 kgf·m, 7 lbf·ft)
- Radiator cover side bolt: 3.4 N·m (0.35 kgf·m, 2.5 lbf·ft)
Installation
Installation is in the reverse order of removal.
Fill and bleed the cooling system (page 6-4).
![](https://motoinstruction.ru/img/honda/9/115744.jpg)