Recommended lubricant: Molydenum disulfide grease
2. Lubricate:
- wheel axle
- wheel bearings
- oil seal lips
Recommended lubricant: Lithium soap base grease
2. Install: rear wheel assembly
a. Install the rear wheel assembly (1) with the rear brake caliper bracket (2 and hold the bracket to keep the specified position.
b. After installation of the rear axle shaft (3), slide the wheel assembly to forward direction.
c. To make sure the caliper bracket mounts on the swingarm and then, fix the holder of swingarm temporally.
Note: The holder should installed with the punch mark (a) facing upper.
d. Tighten the rear gear housing bolts, with specified tightening torque.
- Rear gear housing bolt: 90 Nm (9.0 m·kg)
e. Tighten the nut of rear axle shaft with specified torque.
- Wheel axle nut: 107 Nm (10.7 m·kg)
f. Tighten the rear axle holder with specified torque.
- Rear axle end nut: 23 Nm (2.3 m·kg)
g. Tighten the rear brake caliper bracket bolt with specified tightening torque.
- Brake caliper bracket bolt: 40 Nm (4.0 m·kg)
h. Install the rear brake caliper on the bracket and tighten the bolts with specified tightening torque.
- Brake caliper bolt: 40 Nm (4.0 m·kg)