Caution! Do not hammer the universal joint drive yoke or the collapsible collar may be distorted. This will result in a change in the standard spinning torque, requiring replacement of the collapsible collar and reassembly of the middle driven shaft assembly.
2. Install: bearings (2) (onto the universal joint driven yoke/cross joint)
Caution! The needles can easily fall out of their races, so check each bearing carefully. Slide the universal joint driven yoke assembly back and forth on the bearings. If a needle is out of place, the yoke will not go all the way onto the bearings.
3. Press each bearing into the universal joint driven yoke assembly with a socket of the proper size.
Note: The bearings must be inserted far enough into the universal joint driven yoke assembly so that circlips (3) can be installed.
