a. Remove the circlips (1).
b. Place the universal joint in a press.
c. With a pipe of the proper diameter positioned beneath the universal joint driven yoke as shown, press the bearing into the pipe.
Note: It may be necessary to lightly tap the universal joint driven yoke.
d. Repeat the above steps to remove the opposite side's bearing.
e. Separate the universal joint yokes.
2. Loosen: middle driven shaft nut (1)
Note: While holding the universal joint driven yoke (2) with the universal joint holder (3), loosen the middle driven shaft nut.
- Universal joint holder: 90890-04062