Diagnosis
An access code is required to enter this menu which controls the diagnosis function:
Enter service code
This is a 5-digit code, fixed for each vehicle. For these vehicles, the code is: 12398
If the code is incorrect, the following message is displayed: INCORRECT CODE
and the instrument panel goes back to the main menu. Otherwise, the following menu is displayed:
- Exit
- ECU diagnosis
- Instrument panel errors
- Error Clearing
- Vehicle servicing reset
- Update
- Change keys
- km / miles
ECU diagnosis
In this mode a chart is displayed showing potential errors in the control unit.
It is necessary refer to the error indications given by axone for this vehicle.
The instrument panel does not keep all previous errors stored in its memory.
Instrument panel errors
In this mode, a chart is displayed showing potential errors in the immobilizer and the sensors connected to it.
Instrument panel errors
In this mode, a chart is displayed showing potential errors in the immobilizer and the sensors connected to it.
- DSB 01 - Immobilizer failure: key code read but not recognised.
- DSB 02 - Immobilizer failure: key code not read (key not present or transponder not working)
- DSB 03 - Immobilizer failure: aerial not working (open or short-circuited)
- DSB 04 - Internal controller failure
- DSB 05 - -
- DSB 06 - Ambient air temperature sensor
Error cause
An oil sensor failure is signalled when it is detected that the sensor circuit is open or shorted to positive.
DSB 07 - Oil pressure sensor
Error cause
An oil sensor failure is signalled when, with engine off, it is detected that the sensor circuit is open.
Troubleshooting
The test is performed only once when the key is set to ON. This error is signalled by the bulb icon, and the general warning light turns on as well.
DSB 08 - Oil pressure sensor
Error cause
An oil sensor failure is signalled when, with engine running, it is detected that the sensor circuit is closed.
There is an error when the general warning light turns on.
Troubleshooting
This error is signalled by the bulb icon, and the general warning light turns on as well.
The instrument panel must keep all previous errors stored in its memory.
Delete errors
This option deletes all instrument panel errors; a further confirmation is requested. Use Axone to reset ECU errors.
Vehicle servicing reset
This function is used to reset vehicle servicing. Using this function, the odometer can be reset only once within the first 200 km (124 mi) of the vehicle, provided this has not been done by the Quality Check.
Update
This function is used to program the instrument panel again. This screen page shows the software version currently loaded; the LCD reads:
- Instrument panel disconnected. now connect the diagnosis instrument.
The instrument panel will restart to work normally after the key is inserted-extracted.
Modify keys
With this function the instrument panel can update the keys. Up to 4 keys can be stored.
The user code is first requested to be entered:
- ENTER THE CODE
After entering the correct code, the following message should be shown on the display:
- INSERT THE X KEY
- INSERT THE X+1 KEY
At least one key must be programmed for the next start-ups. If no other key is inserted within 20 seconds or if there is no power or after the fourth key is programmed, the procedure finishes and all the functions of the vehicle and the instrument panel must be enabled (even if only one key has been programmed).
Km / miles
This menu selects the unit of measurement, either for the speed or the total or partial odometers.
- KM
- MILES
Languages
Select the user interface language from this menu.
- ITALIANO
- ENGLISH
- FRANCAIS
- DEUTSCH
- ESPANOL