Removing and installing handlebar (BMW F650GS)
Remove left handlebar fitting.
Remove right handlebar fitting.
Remove impact pad (1).
Loosen clamping screws (2).
Remove handlebar (4) together with clamping blocks (3).
Installation is the reverse of the removal procedure: pay particular attention to the following.
Caution! Note the position of the clamping blocks. Wide hole spacing (arrow) to the front.
Note: The position of the handlebar is indicated by a punch mark (arrow) on the handlebar.
Begin by tightening the front securing screws (as viewed in the forward direction of travel), then tighten the rear securing screws.
Tightening torques:
- Handlebar to fork bridge: 21 Nm
See this article in russian language
This article has been reviewed: Kirill Prokofiev
Similar articles about motorcycles of other brands
Removing and installing handlebar Harley Street 500 (2014-2021)Removing handlebar Yamaha YZF-R1 (2009-2014)
Removing and installing thermostat Kawasaki Versys 650 (2007-2025)
Front Brake Disc — Checking, Removing and Installing Honda CB 400 SF (1992-1999)
Removing the instrument panel side covers Ducati ST2 (1997-2003)
Link to this article in different formats
Comments and feedback from visitors
No comments yet, you will be the first!
- Information for owner
- Introduction to manual
- Maintenance
- Engine and systems
- Engine repair
- Ignition system
- Fuel and exhaust systems
- Cooling system
- Transmission
- Running gear and frame
- Frame and hinged elements
- Handlebar
- Rear suspension
- Brake system
- Wheels and tires
- Electric equipment
- Equipment and devices
- Lighting and lamps