Removing and installing left handlebar lever
Disengage clutch cable (1) from release lever.
Pull cable out of holder (2).
Remove the rubber grommet from the clutch lever.
Make sure that slots in adjusting screw, locknut and lever fitting (arrow) are in line.
Pull back cable shroud (3).
Pull the cable forward through the slot and disengage the nipple.
Slacken the locknut at the handlebar lever
Slacken the pivot pin of the clutch lever.
Installation is the reverse of the removal procedure.
After installing the cable, adjust clutch clearance by setting distance "B" by turning adjusting screw (4) on the clutch handlebar fitting.
Lock adjusting screw (4) with knurled nut (5).
Dimension "B": 1.0...2.0 mm (0.04...0.08 in).
Tightening torques:
- Locknut: 5 Nm
- Pivot pin of clutch lever: 3 Nm
Removing and installing right handlebar lever
Slacken the locknut at the handlebar lever.
Slacken the pivot pin of the handbrake lever.
Installation is the reverse of the removal procedure: pay particular attention to the following.
Tightening torques:
- Locknut of handbrake lever: 7 Nm
- Pivot pin of handbrake lever: 7 Nm