Disengage clutch cable (5) from release lever.
Pull cable out of holder (4).
Remove rubber grommet (1) from clutch lever.
Make sure that slots in adjusting screw, locknut and lever fitting (arrow) are in line.
Pull back cable shroud (2).
Pull the cable forward through the slot and disengage nipple (3).
Pull the cable out to the rear.
Installation is the reverse of the removal procedure: pay particular attention to the following.
Caution! Make sure that the clutch cable is not kinked when installed.
After installing the cable, adjust clutch clearance by setting distance "B" by turning adjusting screw (2) on the clutch handlebar fitting.
Lock adjusting screw (2) with knurled nut (3).
Distance "B": 1.0...2.0 mm (0.04...0.08 in).