Note: Install a new cylinder head gasket.
Install the cylinder head gasket.
Use a wire hook to pull the timing chain through the cavity in the cylinder head.
Fit cylinder head with valves installed to cylinder.
Secure the cylinder head and cylinder loosely together with the collar screws and nuts.
Initially tighten the collar nuts of the cylinder head to 20 Nm (1-4) and then tighten to 60 Nm (5-8).
Tighten the fasteners of the cylinder head to cylinder in the sequence as shown (9-14) to specified torque.
Tighten machine screws at base of cylinder.
Tightening torques:
- Machine screws (chaincase): 10 Nm
- Collar screws for cylinder head: 33 Nm
- Collar nuts to cylinder head:
- stage 1: 20 Nm
- stage 2: 60 Nm