Installing cylinder (BMW F650GS)

0

Fit cylinder base gasket on engine housing: oil bore must be clear.



Oil the piston rings and press the sliding piston ring sleeve, BMW # 11 6 510, over the piston rings from above so that the piston projects from the sliding sleeve by about 2 mm (0.08 in).

Slide timing chain and wire through chain aperture of cylinder, then slide cylinder over piston.

Remove sliding sleeve.

Secure cylinder to engine housing hand-tight.

See this article in russian language

Article about repair motorcycles «BMW F-series F 650 GS» (2000-2007): «Installing cylinder»: https://motoinstruction.ru/en/BMW/F/F650GS/engine/repair/112589 <a href="https://motoinstruction.ru/en/BMW/F/F650GS/engine/repair/112589">Installing cylinder</a> - article about repair motorcycles «BMW F-series F 650 GS» (2000-2007) from section «Engine repair». [url=https://motoinstruction.ru/en/BMW/F/F650GS/engine/repair/112589]Installing cylinder[/url] - article about repair motorcycles «BMW F-series F 650 GS» (2000-2007) from section «Engine repair».