
Caution!
- Switch off ignition.
- Disconnect earth (ground) lead from battery.
- Insulate earth (ground) lead.
Remove the seat.
Remove screws (1) securing top of central electrical equipment box.
Remove screws (2) securing bottom of central electrical equipment box.
Pull cable tray down and remove.
Remove relay and relay base or if necessary, disconnect entire wiring harness and remove complete with fuse box.
Installation is the reverse of the removal procedure.
After installation, shorten the middle rubber lug of the anti-spray fastener (arrow) to 10 mm (0.3937 in).
Switch on the ignition.
Without starting the engine, fully open the throttle once or twice so that the Motronic control unit can register the throttle-valve positions.
Note:
- Disconnecting the battery deletes all entries (e.g. faults, settings) stored in the Motronic control unit’s memory.
- Loss of settings can temporarily impair the operating characteristics when the engine is restarted.