Remove fuel tank.
Remove the battery.
Caution!
- Disconnect the negative battery terminal first, then the positive terminal.
- Connect the positive battery terminal first, then the negative terminal.
Remove Motronic control unit.
[ABS] Remove the unit.
Remove the air intake stub pipe.
Disconnect Bowden cable for starting-speed increase from handlebar fitting.
Disconnect cable from left throttle valve.
Remove Bowden-cable divider from holder.
Pull the battery holder to the left to remove.
Installation is the reverse of the removal procedure.
Switch on the ignition.
Without starting the engine, fully open the throttle once or twice so that the Motronic control unit can register the throttle-valve positions.
Note:
- Disconnecting the battery deletes all entries (e.g. faults, settings) stored in the Motronic control unit's memory.
- Loss of settings can temporarily impair the operating characteristics when the engine is restarted.