Check the endfloat as follows:
- insert a 1.8 mm shim (17) on either side of the engine;
- hold the left arm of swingarm (8) against the engine and measure the clearance on the other side of engine using a feeler gauge or calibrated shims.
The maximum permissible endfloat is 0.1 mm.
When a 0.10 mm feeler gauge or shim can only be inserted with difficulty, there is no need to install any further shims. Otherwise, use the two available shim sizes (0.20 mm and 0.10 mm) to obtain the specified endfloat.
Example:
| Measured endfloat | Shims on left-hand side | Shims on right-hand side |
| 0.10 | - | 1 x 0.10 mm |
| 0.20 | 1 x 0.10 mm | 1 x 0.10 mm |
| 0.50 | 1 x 0.20 mm | 1 x 0.20 mm + 1 x 0.1 mm |
Caution! The thicker of the two shim packs must always be installed on the right-hand side of the swingarm.
The thinnest shim should always be installed so that it is contact with the swingarm.
NEVER install 0.1 mm shims on the left-hands side.
The maximum thickness of the left-hand shim pack must be 2 mm (1.8+0.2 max.).
Side-to-side movement of the rear end of the swingarm must be below 1 mm.