Front wheel construction 1. Nut; 2. Screw; 3. Spacer; 4. Seal; 5. Bearing; 6. Inner spacer; 7. Valve; 8. Front wheel axle; 9. Front wheel rim Caution! Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found...
Removal of the front wheel Support the bike so that the front wheel is raised from the ground. Remove the front brake caliper (B) by unscrewing the two screws (A) securing the caliper to the fork leg; do not disconnect the caliper from the hose. Warning! Do not operate the...
Overhauling the front wheel Overhauling the front wheel bearings Before checking the dimensions, check the wear on wheel bearings. Check for wear by hand after cleaning and degreasing the bearings in their seats. Turn the inner race. Check the amount of radial and axial play....
Refitting the front wheel When all the necessary inspections have been completed, refit the wheel as follows. Lubricate the shank and thread of the wheel axle (8). Insert the front wheel between the fork legs, installing the spacer (3) between the wheel hub and the left fork...
Rear wheel construction 1. Nut; 2. Pin; 3. Slider; 4. Screw; 5. Bearing; 6. Inner spacer; 7. Valve; 8. Wheel; 9. Cush drive bush; 10. Bearing; 11. Brake disc; 12. Screw; 13. Ring Caution! Bold reference numbers in this section identify parts not shown in the figures...
Removal of the rear wheel Unscrew the screws (B) to remove the brake caliper (A) from the mounting bracket, leaving it connected to the braking system. Place the bike on a service stand so that the rear wheel is clear of the ground. Unscrew and remove the whell retaining nut...
Overhauling the rear wheel Remove the sprocket flange from the wheel ( Removal of the rear sprocket ). Refer to " Overhauling the front wheel " for information on how to check the bearings (5) and (10) and the axle (2) and how to overhaul the rear wheel rim (7). Overhauling...
Refitting the rear wheel Install the sprocket flange on the wheel ( Refitting the rear sprocket ). If the special screws of the (4) tensioner slides have been removed, apply grease to the threads and contact face of the nut and fit them to the swingarm. Lock the special...