Recommendations for running a motorcycle In Fig. 51 indicates the limit values of engine speed during the break-in period: 1) up to 1000 km; 2) from 1000 to 2500 km. Pic. 51. Mileage up to 1000 km During the first thousand kilometers, constantly monitor the speed value (rpm). The indicator...
Check before departure Attention! Failure to perform these checks may result in damage to the motorcycle and/or injury to the rider. Check the following before starting the engine. Fuel level in tank Check how much fuel is in the tank. Refuel at necessity ( Here ). Engine...
Starting a motorcycle engine Note. Follow the recommendations «High temperature air» ( page here ) to start a hot engine. Attention! Become familiar with the controls before starting the engine. Normal air temperature (between 10°C and 35°C) Pic. 52. 1) Turn the ignition key to...
Starting the motorcycle 1) Disengage the clutch by pressing the lever all the way. 2) Press the gearshift pedal down with the toe of your left foot. First gear will engage. 3) Increase engine speed using the throttle control while gradually releasing the clutch lever. When...
Motorcycle braking Reduce speed early by using engine braking with downshifts and then apply both brakes (rear and front). Depress the clutch before the motorcycle stops to avoid stalling the engine. Attention For more effective braking, use the front and rear brakes...
Stopping a motorcycle Reduce speed by releasing the accelerator handle to its original position. Alternately shift down to first, then to neutral. Apply the brakes until you come to a complete stop. To turn off the engine turn the key to position 2 (pic. 55). Pic. 55....
Refueling a motorcycle Do not overfill fuel while refueling. The fuel level should be below the bottom edge of the tank filler neck (pic. 56). Pic. 56. Attention! Use low-lead gasoline with an original octane rating of at least 95. Make sure fuel does not get into the cap...
Motorcycle parking Stop and secure the motorcycle using the side support ( see here ). To avoid sliding off the support, turn the steering wheel all the way to the left and turn the ignition key to the steering column lock position (3, fig. 57). Pic. 57. If you park...
Set of tools and accessories The niche under the seat contains: instructions for use and maintenance; helmet fastening cable; kit for regular maintenance and checks. To access the niche, remove the seat ( Here ). Set of tools The toolkit contains: equipment for replacing fuses;...