Introduction to repair manual motorcycle Ducati Monster 696 (2007-2014)

Symbols — abbreviations — references
To allow quick and easy consultation, this manual uses graphic symbols to highlight situations in which maximum care is required, as well as practical advice or information. Pay attention to the meaning of the symbols since they serve to avoid...

Product specifications
Symbols in the diagram show the type of threadlocker, sealant or lubricant to be used at the points indicated. The table below shows the symbols used and the specifications of the various products. SymbolSpecificationsRecommended product Engine oil...

General safety rules
Carbon monoxide When a maintenance operation must be performed with the engine running, maker sure that the working area is well-ventilated. Never run the engine in an enclosed space. Warning! Exhaust fumes contain carbon monoxide, which is a...

General maintenance indications
Useful tips Ducati recommends that you follow the instructions below in order to prevent problems and obtain the best end result: when diagnosing faults, primary consideration should always be given to what the customer reports about motorcycle...

Identification data
Identification data for the Monster 696 i.e. Each Ducati motorcycle has two identification numbers - the frame number and the engine number - and an EC nameplate (A) (not present on the US version). Note: Please quote these numbers, which identify...

Technical specifications
General Reference Technical specifications Motorcycle dimensions Total length 2058 mm Total width 784 mm Total height 1012 mm Wheelbase 1452 mm Height of handlebar grip from ground 960 mm Seat height 770 mm Front footrest height 334 mm Rear footrest...

Fuel, lubricants and other fluids
Fuel, lubricants and other fluids Type dm³ (litres) Fuel tank, including a reserve of 3.5 dm³ (litres) Unleaded fuel with an octane rating of at least 95-98 RON 15 Sump and filter SHELL Advance Ultra 4 3.1 Front/rear brake and clutch circuits SHELL...

Torque settings
Frame torque settings Part Thread/pitch (mm) Nm±10% Tolerance Notes Headlight fairing Screw securing plexiglass to headlight fairing M4x0.7 0.2 Screw securing headlight fairing bracket to headlight support Lower screws initial tighteningUpper screws...

Specific service tools
Specific tools for the engine Code no.Description 88700.5644Socket wrench for camshaft pulley nut 88713.2423Torque wrench for tightening front sprocket nut 88713.2676Wrench for tightening cylinder head nuts 88713.2103Stand for cylinder head assembly...