Removal
XL models - front
1. Remove the fairing side panel (see Chapter 8). On XL650V models, undo the screws and remove the inner trim panel (see illustration).
![](https://motoinstruction.ru/img/honda/19/126035.jpg)
13.1. Undo the screws (arrowed) and remove the inner panel
2. If not already done, twist the bulbholder anti-clockwise and withdraw it from the lens (see illustration).
![](https://motoinstruction.ru/img/honda/19/126036.jpg)
13.2. Release the bulbholder
3. Undo the screws securing the turn signal lens to the fairing side panel, on XL600V models noting the wiring clamp, and remove the lens assembly, noting how it fits (see illustrations).
![](https://motoinstruction.ru/img/honda/19/126037.jpg)
13.3a. Turn signal screws (arrowed) - XL600V
![](https://motoinstruction.ru/img/honda/19/126038.jpg)
13.3b. Turn signal screws (arrowed) - XL650V
XRV models - front
4. Trace the wiring from the turn signal and disconnect it at the connectors (see illustration) - on L to N (1990 to 1992) models, remove the cockpit trim panel to improve access if required (see Chapter 8).
![](https://motoinstruction.ru/img/honda/19/126039.jpg)
13.4. Disconnect the relevant wiring connectors...
5. Unscrew the nut securing the stem to the inside of the bracket (see illustration). Remove the turn signal, noting how it locates in the bracket, and taking care as you draw the wiring through.
![](https://motoinstruction.ru/img/honda/19/126040.jpg)
13.5 ...then unscrew the nut (arrowed) and remove the turn signal
All models - rear
6. Remove the seat (see Chapter 8). On XRV750-P models onwards (1993 on), remove the right-hand side panel (see Chapter 8).
7. Trace the wiring from the turn signal and disconnect the wiring connectors (see illustration or 10.2a or 10.4). Carefully draw the wiring through to the stem, taking care not to snag it.
![](https://motoinstruction.ru/img/honda/19/126041.jpg)
13.7. Rear turn signal wiring connectors - XL650V
8. Unscrew the nut securing the stem, and where fitted remove the washer (see illustrations). Remove the turn signal, again taking care as you draw the wiring through.
![](https://motoinstruction.ru/img/honda/19/126042.jpg)
13.8a. Rear turn signai nut (arrowed) - XL600V
![](https://motoinstruction.ru/img/honda/19/126043.jpg)
13.8b. Rear turn signal nut (arrowed) - XL650V
![](https://motoinstruction.ru/img/honda/19/126044.jpg)
13.8c. Rear turn signal nut (arrowed) - XRV750
Installation
9. Installation is the reverse of removal. Check the operation of the turn signals.