Removal
1. Remove the seat (see Chapter 8). On XRV750-P models onward (1993-on), remove the right-hand side panel (see Chapter 8).
2. On XL600V models, disconnect the tail light wiring connectors (see illustration). Support the tail light, then undo the nuts on the inside of the rear mudguard and remove the washers and rubbers (see illustration). Draw the tail light out and remove it, noting how it fits.
![](https://motoinstruction.ru/img/honda/19/126018.jpg)
10.2a. On XL600V models the tail light and turn signal wiring connectors are inside the boot (arrowed)
![](https://motoinstruction.ru/img/honda/19/126019.jpg)
10.2b. Tail light assembly nuts (arrowed)
3. On XL650V models, remove the luggage rack and tail light cover (see Chapter 8). Either disconnect the wiring connector from the bulbholder (see illustration), or turn the bulbholder anti-clockwise and withdraw it from the tail light (see illustration 9.3a). Support the tail light, then unscrew the two bolts and draw the light out the back (see illustration). Note the collars in the rubber mounts and remove them if required. Check the condition of the rubbers and replace them with new ones if they are damaged, deformed or deteriorated.
![](https://motoinstruction.ru/img/honda/19/126020.jpg)
10.3a. Tail light wiring connector (arrowed)...
![](https://motoinstruction.ru/img/honda/19/126021.jpg)
10.3b ...and mounting bolts (arrowed) - XL650V
4. On XRV750 models, disconnect the tail light wiring connector, located in the rubber boot (see illustration). Support the tail light, then undo the bolts on the inside of the rear mudguard. Draw the tail light out and remove it, noting how it fits.
![](https://motoinstruction.ru/img/honda/19/126022.jpg)
10.4. On XRV750 models the tail light and turn signal wiring connectors are inside the boot (arrowed)
Installation
5. Installation is the reverse of removal. Check the operation of the tail and brake lights.