![](https://motoinstruction.ru/img/honda/9/115765.jpg)
General
Do not support the engine using the oil filter.
A floor jack or other adjustable support is required to support and maneuver the engine.
It is recommended to use two steel poles to help remove and install the engine. These poles will go through the front and rear upper engine mounts, and the engine can then be carried out of the frame. See the illustrations below for pole specifications.
FRONT:
- Pole:
- 1371 mm (54 in)
- Holes:
- 140 mm (5.5 in)
- 686 mm (27 in) off center
![](https://motoinstruction.ru/img/honda/9/115766.jpg)
REAR:
- Pole:
- 1371 mm (54 in)
- Holes:
- 79.4 mm (3.125 in)
- 686 mm (27 in) off center
![](https://motoinstruction.ru/img/honda/9/115767.jpg)
When removing and installing the engine, tape the frame around the engine beforehand for frame protection.
![](https://motoinstruction.ru/img/honda/9/115768.jpg)
The following components require engine removal for service.
- Oil pump (Section 4)
- Water pump (Section 6)
- Cylinder head/camshaft (Section 8)
- Cylinder/piston (Section 9)
- Crankshaft (Section 11)
- Transmission/shift drum/shift fork (Section 11)
- Output gear (Section 11)
The following components can be serviced with the engine in the frame.
- Throttle body (Section 5)
- Clutch/gearshift linkage (Section 10)
- Alternator (Section 16)
- Starter clutch/flywheel (Section 18)
- Starter motor (Section 18)
Specification
ITEM | STANDARD |
Engine dry weight | 122.5 kg (270 lbs) |
Engine oil capacity at disassembly | 4.5 litter (4.8 US qt, 4.0 Imp qt) |
Coolant capacity (radiator and engine) | 2.6 litter (2.75 US qt, 2.29 Imp qt) |
Torque values
Front upper engine mounting nut | 54 N·m (5.5 kgf·m, 40 lbf·ft) |
Front lower engine mounting nut | 54 N·m (5.5 kgf·m, 40 lbf·ft) |
Rear upper engine mounting nut | 54 N·m (5.5 kgf·m, 40 lbf·ft) |
Rear lower engine mounting nut | 54 N·m (5.5 kgf·m, 40 lbf·ft) |
Right front upper engine hanger plate bolt | 26 N·m (2.7 kgf·m, 20 lbf·ft) |
Left front upper engine hanger plate bolt | 26 N·m (2.7 kgf·m, 20 lbf·ft) |
Right front lower engine hanger plate nut | 39 N·m (4.0 kgf·m, 29 lbf·ft) |
Rear upper engine hanger plate bolt | 26 N·m (2.7 kgf·m, 20 lbf·ft) |
Rear lower engine hanger plate bolt | 26 N·m (2.7 kgf·m, 20 lbf·ft) |
Starter motor cable terminal nut | 7 N·m (0.7 kgf·m, 5.1 lbf·ft) |