Rear suspension units — installation (Triumph Rocket III)

0

1. Locate the suspension units to the mounting spigots, articulating the swinging arm until the distance between the upper and lower spigots allows the units to fit.

2. Fit the original washers to new mounting bolts. Install the bolts then tighten them to 28 Nm.

Note: The large washer is fitted to the top mounting, the smaller washer to the lower.

3. Repeat operations 1 and 2 for the other rear suspension unit (if removed).

4. Remove the wheel support (if fitted), lower the motorcycle to the ground and park it on the side stand.

See this article in russian language

Article about repair motorcycles «Triumph Rocket III» (2004-2018): «Rear suspension units — installation»: https://motoinstruction.ru/en/Triumph/Rocket/III/chassis/rsusp/111939 <a href="https://motoinstruction.ru/en/Triumph/Rocket/III/chassis/rsusp/111939">Rear suspension units — installation</a> - article about repair motorcycles «Triumph Rocket III» (2004-2018) from section «Rear suspension». [url=https://motoinstruction.ru/en/Triumph/Rocket/III/chassis/rsusp/111939]Rear suspension units — installation[/url] - article about repair motorcycles «Triumph Rocket III» (2004-2018) from section «Rear suspension».