Replacing spark plugs/ignition leads (BMW K1200LT)

0

Remove left-hand side of engine spoiler.

See Group 46.

• Remove heat shield (3).
• Pull off spark plug caps with flat pliers.

Removing and installing spark plugs

• Remove spark plugs with spark plug wrench, BMW No. 123500.
• Installation is the reverse of the removal procedure.

Tightening torques:

• Spark plugs — 20 Nm

Removing and installing ignition leads

• Shield housing. Remove screws (1) and lift off cover (2).
• Disconnect ignition leads from ignition coil.
• Remove ignition leads.

Note: When installing, make sure that the ignition leads are correctly routed.

• Installation is the reverse of the removal procedure.

Tightening torques:

• Cover of shield housing — 5 Nm

See this article in russian language

Article about repair motorcycles «BMW K-series K 1200 LT» (1998-2009): «Replacing spark plugs/ignition leads»: https://motoinstruction.ru/en/BMW/K/K1200LT/engine/starter/115733 <a href="https://motoinstruction.ru/en/BMW/K/K1200LT/engine/starter/115733">Replacing spark plugs/ignition leads</a> - article about repair motorcycles «BMW K-series K 1200 LT» (1998-2009) from section «Starting and charging system». [url=https://motoinstruction.ru/en/BMW/K/K1200LT/engine/starter/115733]Replacing spark plugs/ignition leads[/url] - article about repair motorcycles «BMW K-series K 1200 LT» (1998-2009) from section «Starting and charging system».