Removal
Remove the air cleaner housing (see Fuel System chapter).
Disconnect the stick coil connectors [A].
Pull the stick coils [B] off the spark plugs.
![](https://motoinstruction.ru/img/kawasaki/5/113691.jpg)
Caution! Do not pry the connector part of the coil while removing the coil.
Installation
Install the coil using the following steps.
Insert the coil as shown being careful of the coil head [A] direction.
Connect the connectors [В].
Stick coil connectors angle [C]: about 45°.
![](https://motoinstruction.ru/img/kawasaki/5/113692.jpg)
Caution! Do not tap the coil head while installing the coil.
Inspection
Remove the stick coils (see this chapter).
Measure the primary winding resistance [A] as follows.
Connect the hand tester between the coil terminals.
Set the tester to the x 1 Ω range, and read the tester.
Measure the secondary winding resistance [B] as follows.
![](https://motoinstruction.ru/img/kawasaki/5/113693.jpg)
Connect the tester between the plug terminal and (-) coil terminal
Set the tester to the x 1 kΩ range and read the tester.
Ignition coil winding resistance:
Primary Windings: 1.2-1.6 Ω
Secondary Windings: 8.5-11.5 kΩ
★ If the tester does not read as specified, replace the coil.