Checking brake fluid level Caution: Do not allow brake fluid to come into contact with painted parts of the motorcycle, because brake fluid destroys paint. Front brake Place the motorcycle on its centre stand so that it is level. Release the fastener (4) and remove the top...
Checking clutch fluid level Place the motorcycle on its centre stand so that it is level. Turn the handlebars to full right lock. Note: The level of fluid in the expansion tank rises as the clutch lining wears. Check the level of clutch fluid at the inspection glass. Warning:...
Checking tyre pressures Check/correct tyre pressures. Tyre pressures: One-up — front 2.5 bar (35.6 psi) One-up — rear 2.9 bar (41.2 psi) Two-up — front 2.5 bar (35.6 psi) Two-up — rear 2.9 bar (41.2 psi) Two-up with luggage — front 2.5 bar (35.6 psi) Two-up with luggage —...
Installing the aerial Place cap (3) on aerial. Tighten stub aerial (2) to aerial bracket (1) Cap (3) has a bayonet fitting: turn it clockwise 1/8 of a turn to secure. Tightening torques: Nut, stub aerial — 3 Nm
Installing the windscreen Slightly raise the windscreen linkage. Install windscreen and retaining plate (3). Tighten the four screws (1) (micro-encapsulated). Note: It may be necessary to bend the inner clips (2) to ensure that the plate retains the windscreen properly....
Checking and adjusting the motorcycle Checking the function of side stand contact switch Switch off the engine. Place motorcycle on its centre stand. Select a gear and switch on the ignition. Temperature gauge warning light lights up. Extend the side stand, observing the temperature...
Final inspection and function check Fill up with fuel. Check engine oil when engine is cold, top up if necessary. Check clutch. Check gear shift action. Check reverser. Check handbrake and foot brake Check lights and signalling equipment: Front and rear parking lights Low and high...
Final cleaning Clean the motorcycle. Note: Do not use a steam or high-pressure water jet. The high steam or water pressure could damage seals, the hydraulic system or electrical components.