Engine start and battery charging system of motorcycle BMW K1200LT (1998-2009)
See this section in russian language
Technical Data of engine electrics
Technical DataK1200 LT Starter motor TypePermanent-magnet motor Gear ratio27:1 Power rating, kW0.7 Three-phase generator TypeThree-phase AC generator Gear ratio1:1.5 Drivedirect Maximum output rating, W/V840/14 Maximum current, A60 Three-phase...
Technical DataK1200 LT Starter motor TypePermanent-magnet motor Gear ratio27:1 Power rating, kW0.7 Three-phase generator TypeThree-phase AC generator Gear ratio1:1.5 Drivedirect Maximum output rating, W/V840/14 Maximum current, A60 Three-phase...
Removing and installing Hall-effect transmitters
Preparatory work Remove left and right fairing side sections. See Group 46. Remove centre and right sections of engine spoiler. Remove right skirt bracket. Caution: Switch off the ignition and disconnect and insulate the earth (ground) lead at the...
Preparatory work Remove left and right fairing side sections. See Group 46. Remove centre and right sections of engine spoiler. Remove right skirt bracket. Caution: Switch off the ignition and disconnect and insulate the earth (ground) lead at the...
Replacing spark plugs/ignition leads
Remove left-hand side of engine spoiler. See Group 46. Remove heat shield (3). Pull off spark plug caps with flat pliers. Removing and installing spark plugs Remove spark plugs with spark plug wrench, BMW # 123500. Installation is the reverse of the...
Remove left-hand side of engine spoiler. See Group 46. Remove heat shield (3). Pull off spark plug caps with flat pliers. Removing and installing spark plugs Remove spark plugs with spark plug wrench, BMW # 123500. Installation is the reverse of the...
Timing the ignition
Preparatory work Remove left and right fairing side sections. See Group 46. Remove left and right engine spoilers. Remove right skirt bracket. Remove fuel tank. See Group 16. Remove the right-hand air outlet duct from the radiator. See Group 17....
Preparatory work Remove left and right fairing side sections. See Group 46. Remove left and right engine spoilers. Remove right skirt bracket. Remove fuel tank. See Group 16. Remove the right-hand air outlet duct from the radiator. See Group 17....
Replacing three-phase generator
Removing and installing three-phase generator Note: It is not necessary to remove the gearshift linkage, gearbox and clutch slave cylinder. Raise the frame. Removing gearbox Remove the three securing screws (1). Pull the three-phase generator off...
Removing and installing three-phase generator Note: It is not necessary to remove the gearshift linkage, gearbox and clutch slave cylinder. Raise the frame. Removing gearbox Remove the three securing screws (1). Pull the three-phase generator off...
Replacing starter motor
Removing and installing starter motor Remove gearbox complete with starter motor. See Group 23. Remove screw (6) and remove the starter motor. When reinstalling begin by introducing the starter motor into the intermediate flange, then install the...
Removing and installing starter motor Remove gearbox complete with starter motor. See Group 23. Remove screw (6) and remove the starter motor. When reinstalling begin by introducing the starter motor into the intermediate flange, then install the...
Similar sections of other motorcycles
Starting and charging system Harley Street 500 (2014-2021)Starting and charging system Kawasaki ZX6R/ZX600J (2000-2002, 3 generation)
Starting and charging system Aprilia RS 125/3 (1998-2005, 3 generation)
Starting and charging system Triumph Rocket III (2004-2018)
Starting and charging system Honda Africa Twin 750 (1989-2003)
- Information for owner
- Introduction to manual
- Weekly checks
- Maintenance
- Engine and systems
- Engine repair
- Starting and charging system
- Fuel and exhaust systems
- Cooling system
- Transmission
- Running gear and frame
- Frame and hinged elements
- Front suspension and fork
- Rear wheel drive
- Handlebar
- Brake system
- Wheels and tires
- Electric equipment
- Equipment and devices