Removing radial shaft seal from crankshaft with engine installed (BMW R1150GS)

0

Lock clutch housing with special tool, BMW No. 115640.

Remove the clutch.



Carefully lever out radial shaft seal, using a screwdriver.

Caution! Take care not to damage the sealing faces of crankcase and crankshaft.

Note: The radial shaft seals can be removed when the crankcase is disassembled.

Using awl, BMW No. 008583, carefully punch a hole in the shaft sealing ring.

Screw the pull rod, BMW No. 008581, into the pierced hole and use impact weight, BMW No. 00 8 582, to remove the shaft sealing ring.

See this article in russian language

Article about repair motorcycles «BMW R-series R 1150 GS» (1999-2004): «Removing radial shaft seal from crankshaft with engine installed»: https://motoinstruction.ru/en/BMW/R/R1150GS/engine/repair/111625 <a href="https://motoinstruction.ru/en/BMW/R/R1150GS/engine/repair/111625">Removing radial shaft seal from crankshaft with engine installed</a> - article about repair motorcycles «BMW R-series R 1150 GS» (1999-2004) from section «Engine repair». [url=https://motoinstruction.ru/en/BMW/R/R1150GS/engine/repair/111625]Removing radial shaft seal from crankshaft with engine installed[/url] - article about repair motorcycles «BMW R-series R 1150 GS» (1999-2004) from section «Engine repair».