Refitting the seat release mechanism (Ducati Monster 696)

0

Fit the seat lock (27) in the housing in the spray guard (1), inserting the lugs (C) in the slots (D) as shown in the figure.



Fit the lock lever (29) inserting the lugs (C) in the slots (E) as shown in the figure.



Fit the nut (28) on the seat lock (27) and tighten to the specified torque (Frame tightening torques).



Position the lock cable (26) on the spray guard (1), as shown in the figure.



Refit the cable end fitting (B) in th elock lever (29) and end fitting (A) in the latch (31).





Refit the spray guard (1) to the protection (3) and tighten the screws (7) to the specified torque (Frame tightening torques).



Refit the tail light - number plate holder assembly from the rear subframe and the plate (24) as described in the previous paragraph.

See this article in russian language

Article about repair motorcycles «Ducati Monster 696» (2007-2014): «Refitting the seat release mechanism»: https://motoinstruction.ru/en/Ducati/Monster/696/chassis/frame/114850 <a href="https://motoinstruction.ru/en/Ducati/Monster/696/chassis/frame/114850">Refitting the seat release mechanism</a> - article about repair motorcycles «Ducati Monster 696» (2007-2014) from section «Frame and hinged elements». [url=https://motoinstruction.ru/en/Ducati/Monster/696/chassis/frame/114850]Refitting the seat release mechanism[/url] - article about repair motorcycles «Ducati Monster 696» (2007-2014) from section «Frame and hinged elements».