Remove
Seat
1. See Figure 3-73. Remove seat.
- a. Remove seat retention screw (5).
- b. Slide seat (1) back to release from seat retention tab (3).
- c. Slide seat forward and lift above the fuel tank (2).
- d. Pull seat forward through seat strap (4).
Seat Retention Nut
1. See Figure 3-74. Remove seat retention nut.
- a. Hold nut (1).
- b. Remove clip (2).
Seat Strap
1. See Figure 3-75. Remove seat strap.
- a. Remove screws and washers (2-3).
- b. Remove strap (1).
![](https://motoinstruction.ru/img/harley/22/127756.jpg)
Figure 3-74. Seat Rentention Nut: 1. Nut; 2. Clip; 3. Rear fender
![](https://motoinstruction.ru/img/harley/22/127757.jpg)
Figure 3-73. Seat Removal: 1. Seat; 2. Fuel tank; 3. Seat retention tab; 4. Seat strap; 5. Seat retention nut; 6. Seat retention screw
![](https://motoinstruction.ru/img/harley/22/127758.jpg)
Figure 3-75. Seat Strap: 1. Seat strap; 2. Screw (2); 3. Washer (2); 4. Hole (2)
Install
FASTENER | TORQUE VALUE | |
Seat retention screw | 2.3-4.5 Nm | 21-39 in·lbs |
Seat strap screw | 9.0-11.0 Nm | 80-97 in·lbs |
Seat
Warning: After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury.
1. See Figure 3-73. Install seat.
- a. Insert rear of seat (1) through seat strap (4).
- b. Slide seat forward and on to seat retention tab (3).
- c. Install seat retention screw (5). Tighten to 2.3-4.5 Nm (21-39 in·lbs).
Seat Retention Nut
1. See Figure 3-74. Install seat retention nut.
- a. Align nut (1) with hole in rear fender (3).
- b. Insert nut through rear fender.
- c. Install clip (2).
Seat Strap
1. See Figure 3-75. Install seat strap.
- a. Align strap (1) as shown.
- b. Install screws and washers (2-3) though holes (4) in strap. Tighten to 9.0-11.0 Nm (80-97 in·lbs).