Removing the seat end cover (Aprilia RS125/3)
- Main
- Aprilia
- RS-series
- RS 125 [3]
- Running gear and frame
- Frame and hinged elements
- Removing the seat end cover
Torque wrench settings:
Remove the seat; see 7.1.1.
Release and remove the two screws (1) on both sides.
Release and remove the four screws (2).
Lower the seat end cover.
Remove the flasher (3) from its housing.
Remove the number plate bracket; see 7.1.13.
Unscrew the two screws (4) and collect the nut.
Remove the ECU.
Pull the seat end cover in a rearward motion to remove.
- Screws (1): 2 Nm (0.2 Kgm).
- Screws (2): 3 Nm (0.3 Kgm).
- Screws (4): 3 Nm (0.3 Kgm).
Remove the seat; see 7.1.1.
Release and remove the two screws (1) on both sides.
Release and remove the four screws (2).
Lower the seat end cover.
Remove the flasher (3) from its housing.
Remove the number plate bracket; see 7.1.13.
Unscrew the two screws (4) and collect the nut.
Remove the ECU.
Pull the seat end cover in a rearward motion to remove.
See this article in russian language
This article has been reviewed: Artemy Kuzmin
Similar articles about motorcycles of other brands
Clip, Seat, Sport, Rear Frame Cover, Side Cowling Cover… Suzuki 1000A/XA V-Strom (2014-2019)Removing the clutch cover Yamaha FZ1 Fazer (2006-2015)
Seat cover — removal and installation Kawasaki ZX6R/ZX600J (2000-2002)
Removing and installing the seat Honda VTX 1800 C (2001-2008)
Removing the gear change lever, the sprocket cover and the… Ducati ST2 (1997-2003)
Link to this article in different formats
Comments and feedback from visitors
No comments yet, you will be the first!
- Information for owner
- Introduction to manual
- Maintenance
- Troubleshooting
- Engine and systems
- Engine repair
- Fuel system
- Cooling and lube system
- Running gear and frame
- Frame and hinged elements
- Front suspension and handlebar
- Rear suspension
- Brake system
- Wheels and tires
- Electric equipment
- Equipment and devices
- Starting and charging system