Remove
1. Battery; 2. Battery strap; 3. Positive (red) terminal; 4. Negative terminal
1. Remove the rider's seat.
2. Lift up the tool box at its front edge and pivot it towards the rear of the motorcycle.
3. Remove the battery strap.
4. Disconnect the battery leads, negative (black) lead first.
5. Take the battery out of the case.
Warning! Ensure that the battery terminals do not touch the motorcycle frame as this may cause a short circuit or spark, which would ignite battery gases causing a risk of personal injury.
Installation
Warning! Ensure that the battery terminals do not touch the motorcycle frame as this may cause a short circuit or spark, which would ignite battery gases causing a risk of personal injury.
1. Place the battery in the battery case,
2. Reconnect the battery, positive (red) lead first.
3. Apply a light coat of grease to the terminals to prevent corrosion.
4, Cover the positive terminal with the protective cap.
5. Refit the battery strap.
6. Lower the tool kit tray into place.
7. Refit the rider's seat as described on page 17.9.