2. Apply silicone sealer to the cable grommet and align the cable to the crankcase exit slot.
3. Fit the cable retainer bracket, routing the cables as noted on strip down. Tighten the retainer bolts to 12 Nm.
1. Stator; 2. Cable retainer bracket; 3. Fixings
4. Tighten the stator bolts to 12 Nm.
5. Assemble the rotor to the keyway on the crankshaft.
6. Fit the bolt and washer to the threaded hole in the crankshaft.
7. Refit tool T3880201 to prevent the crankshaft from rotating.
8. Tighten the rotor bolt to 120 Nm.
1. Rotor; 2. Rotor bolt; 3. Tool T3880201
9. Remove tool T3880201.
10. Incorporating a new gasket, refit the alternator cover to the rear of the engine.
11. Tighten the alternator cover bolts to 9 Nm.
12. Incorporating a new О-ring seal, fit the starter motor and tighten the starter fixings to 27 Nm.
13. Refit the engine as described on page 10.5.
14. Reconnect the battery positive (red) lead first.
15. Refit the rider's seat.