1. Remove:
- piston pin clip (1)
- piston pin (2)
- piston (3)
Caution! Do not use a hammer to drive the piston pin out.
Note:
- Before removing the piston pin clip, cover the crankcase opening with a clean rag to prevent the piston pin clip from falling into the crankcase.
- For reference during installation, put an identification mark on each piston crown.
- Before removing the piston pin, deburr the piston pin clip's groove and the piston's pin bore area. If both areas are deburred and the piston pin is still difficult to remove, remove it with the piston pin puller (4).
- Piston pin puller: 90890-01304
2. Remove:
- top ring
- 2nd ring
- oil ring
Note: When removing a piston ring, open the end gap with your fingers and lift the other side of the ring over the piston crown.
