Function
It tells the side stand position to the control unit.
Operating principle
If the gear is engaged and the side stand is unfolded, and therefore the circuit is open, the control unit does not enable vehicle start-up or shuts off the engine if it is rotating.
Level in wiring diagram: start-up enabling switches
Location:
- on the vehicle: on the side stand
- connector: left side, near the Marelli control unit
Electrical characteristics:
- Side Stand Up: closed circuit (continuity)
- Side Stand Down: open circuit (infinite resistance)
Pin-out:
- 1. Ground connection
- 2. Voltage 12V
Caution! Before carrying out any troubleshooting, carefully read the general troubleshooting concepts for electrical devices at the beginning of the check and control section in the electrical system chapter.
Axone: statuses
Side stand
Example value: up/down
Indication on Axone always down: check the connector: if not OK, restore; if it is OK, disconnect the two terminals from the sensor and check continuity to ground of PIN 1: if there is no continuity, restore the cable harness; if there is, replace the sensor.
Indication on Axone always up: disconnect the terminals from the sensor and check if there is continuity between the two PINS, with stand down: if there is continuity, replace the sensor; if the circuit is open, it means that the brown/green cable from sensor PIN 2 to ENGINE connector PIN 6 is short circuit to ground: restore the cable harness.