Engine oil pressure sensor (Aprilia Shiver 750)
- Main
- Aprilia
- Shiver
- SL 750
- Electric equipment
- Equipment and devices
- Engine oil pressure sensor
Function: it indicates to the instrument panel if there is enough oil pressure (0.5 +/- 0.2 bar (7.25 +/- 2.9 PSI)) in the engine.
Operation / Operating principle: normally closed switch. With oil pressure above 0.5 +/-0.2 bar (7.25 +/- 2.9 PSI), open circuit.
Location on the vehicle: right side of the vehicle, under the oil sump
Pin-out: Voltage 5V
Error DSB 07
Error cause
An oil sensor failure is signalled when, with engine off, it is detected that the sensor circuit is open. The test is performed only once when the key is set to ON. This error is signalled by the bulb icon and the general warning light turns on as well.
Troubleshooting
Check the sensor connector and the instrument panel connector (PIN 17): If not OK, restore. If OK, check the continuity of the purple cable between the sensor connector and the instrument panel connector PIN 17: if not OK, restore the cable harness; if OK, replace the sensor.
Error DSB 08
Error cause
An oil sensor failure is signalled when, with engine running, it is detected that the sensor circuit is closed. This error is signalled by the bulb icon and the general warning light turns on as well.
Troubleshooting
Check if oil pressure is low with the specific gauge.
Operation / Operating principle: normally closed switch. With oil pressure above 0.5 +/-0.2 bar (7.25 +/- 2.9 PSI), open circuit.
Location on the vehicle: right side of the vehicle, under the oil sump
Pin-out: Voltage 5V
 |
 |
Instrument panel
Error DSB 07
Error cause
An oil sensor failure is signalled when, with engine off, it is detected that the sensor circuit is open. The test is performed only once when the key is set to ON. This error is signalled by the bulb icon and the general warning light turns on as well.
Troubleshooting
Check the sensor connector and the instrument panel connector (PIN 17): If not OK, restore. If OK, check the continuity of the purple cable between the sensor connector and the instrument panel connector PIN 17: if not OK, restore the cable harness; if OK, replace the sensor.
Error DSB 08
Error cause
An oil sensor failure is signalled when, with engine running, it is detected that the sensor circuit is closed. This error is signalled by the bulb icon and the general warning light turns on as well.
Troubleshooting
Check if oil pressure is low with the specific gauge.
See this article in russian language
This article has been reviewed: Serafim Sazonov
Similar articles about motorcycles of other brands
Engine oil pressure indicator/EOP switch (CRF1000/A)/EOP… Honda Africa Twin 1000 (2015-2020)Ambient pressure sensor — pinpoint tests Triumph Rocket III (2004-2018)
Checking the atmospheric pressure sensor Yamaha FZ1 Fazer (2006-2015)
Engine coolant temperature sensor — removal, installation… Suzuki V-Strom DL-1000K2/K9 (2002-2012)
Inlet air pressure sensor (service code 12) Kawasaki Vulcan VN 900 (2006-2024)
Link to this article in different formats
Comments and feedback from visitors
No comments yet, you will be the first!
- Information for owner
- Introduction to manual
- Control devices
- Operation manual
- Technical characteristics
- Maintenance
- Engine and systems
- Engine repair
- Lubrication system
- Cooling system
- Fuel system
- Transmission
- Running gear and frame
- Frame and hinged elements
- Front suspension and handlebar
- Rear suspension
- Brake system
- Electric equipment
- Equipment and devices