Engine removal — vehicle preparation (Aprilia Shiver 750)
- Main
- Aprilia
- Shiver
- SL 750
- Engine and systems
- Engine repair
- Engine removal — vehicle prepa…
Remove the air filter case.
Remove the coolant radiator.
Remove the exhaust system.
Place the optional under-sump and rear wheel service stands.
Undo and remove the screw and move the coil.
Disconnect the engine temperature sensor connector.
Disconnect the horn connectors.
Disconnect the engine oil pressure sensor connector.
Disconnect the starter motor power supply cable.
Undo and remove the screw and collect the washer.
Disconnect the ground leads.
Move the breather pipe.
[The original text is on the website MOTOINSTRUCTION.ru]
Disconnect the speed sensor connector.
Undo and remove the three screws.
Remove the clutch control cylinder. Lock the plunger using a clamp.
Undo and remove the two screws.
Remove the chain guard.
Undo and remove the three screws fixing the chain guide.
Remove the clutch pin.
Disconnect the gear in neutral sensor connector.
Disconnect the side stand sensor connector.
Loosen the screw and slide off the gear transmission connecting rod keeping it linked to the gear shift lever through the rod.
Slacken the gearing chain tension.
Undo and remove the screw; collect the washer and the spacer.
Slide off the pinion from the chain and remove.
Disconnect the generator connections.
See also specifications for this operation: front chassis, centre frame, engine.
Remove the coolant radiator.
Remove the exhaust system.
Place the optional under-sump and rear wheel service stands.
Undo and remove the screw and move the coil.
Disconnect the engine temperature sensor connector.
Disconnect the horn connectors.
Disconnect the engine oil pressure sensor connector.
Disconnect the starter motor power supply cable.
Undo and remove the screw and collect the washer.
Disconnect the ground leads.
Move the breather pipe.
[The original text is on the website MOTOINSTRUCTION.ru]
Disconnect the speed sensor connector.
Undo and remove the three screws.
Remove the clutch control cylinder. Lock the plunger using a clamp.
Undo and remove the two screws.
Remove the chain guard.
Undo and remove the three screws fixing the chain guide.
Remove the clutch pin.
Caution! Upon refitting, properly grease the O-ring indicated with the arrow and be careful not to pinch it.
Disconnect the gear in neutral sensor connector.
Disconnect the side stand sensor connector.
Loosen the screw and slide off the gear transmission connecting rod keeping it linked to the gear shift lever through the rod.
Slacken the gearing chain tension.
Undo and remove the screw; collect the washer and the spacer.
Slide off the pinion from the chain and remove.
Disconnect the generator connections.
See also specifications for this operation: front chassis, centre frame, engine.
See this article in russian language
This article has been reviewed: Serafim Sazonov
Similar articles about motorcycles of other brands
Engine oil and filter Suzuki DRZ 250 (1996-2007)Engine oil specification Triumph Rocket III (2004-2018)
Tachometer (engine speed indicator) Yamaha FZ1 Fazer (2006-2015)
Engine top end exploded view Kawasaki ZX6R/ZX600J (2000-2002)
Starting the engine Honda CB 400 SF (1992-1999)
Link to this article in different formats
Comments and feedback from visitors
No comments yet, you will be the first!
- Information for owner
- Introduction to manual
- Control devices
- Operation manual
- Technical characteristics
- Maintenance
- Engine and systems
- Engine repair
- Lubrication system
- Cooling system
- Fuel system
- Transmission
- Running gear and frame
- Frame and hinged elements
- Front suspension and handlebar
- Rear suspension
- Brake system
- Electric equipment
- Equipment and devices