Disconnect the instrument panel connector (A) from the main wiring harness (see plates in the chapter "Routing of wiring on frame").
Disconnect theheadlight wiring connector (B) and the front turn indicator connectors from the main wiring harness connector (see plates in the chapter "Routing of wiring on frame").
Unscrew the nuts (2) securing the front light assembly to the bottom yoke.
Remove the front light assembly, withdrawing the pins (C) from the support bracket.
Release the headlight from the front light assembly by unscrewing the screws (3).
Remove the front turn indicators (4) by removing the circlip (5) and unscrewing the screw (6).
Note: On the USA version a spacer is installed between the turn indicator and the front light asssembly support.
Refitting is the reverse of removal:
- check that the rubber mountings (7) are installed on the headlight;
- apply the recommended grease to the washers (8);
- reconnect the wiring connectors of the headlight (B) and the front turn indicators;
- tighten the screws (3), (6) and nuts (2) to the specified torque (Frame torque settings).
