The information on the display can be accessed using a 2-position rocker switch (1) and the headlight flasher button (2) on the left-hand handlebar switch.
Underneath the digital display there are six indicator lights (three per side) and a further auxiliary light that illuminates when the engine rpm approaches the rev limiter threshold.
The instrument panel is equipped with a sensor that detects the intensity of the ambient light. The instrument panel automatically switches its backlighting on or off according to the intensity of light detected. The instrument panel also has an internal temperature sensor which, if the temperature rises above 70°C, switches off the backlighting to prevent possible damage.
The instrument panel also houses the atmospheric pressure sensor: the engine ECU acquires this signal via the CAN (Controller Area Network) serial communication line.
Indicator lights
The following indicator lights are mounted on the instrument panel.
3) Neutral light (green): illuminates when the gearbox is in neutral.
4) Low fuel light (yellow): illuminates when there are approximately 3.5 litres of fuel left in the tank.
5) Turn signal lights (green): illuminate and flash when the corresponding turn signal is in operation.
6) Engine oil pressure light (red): illuminates when the engine oil pressure is too low. This light should come on when the ignition is switched to ON and normally goes out a few seconds after engine starts. It may come on briefly if the engine is very hot, but should go out again as engine speed increases.
7) High beam warning light (blue): illuminates when the high beam headlight is on.
8) EOBD Engine diagnostics warning light: switches on permanently in the event of a problem with the engine and/or injection system.
9) Over Rev. indicator lights: Illuminate steadily at 800 rpm before intervention of the rev limiter. Starts flashing when the rev limiter is reached.
