XL models
FASTENER | TORQUE VALUE | |
Passenger footrest support bracket fastener: XL Models | 45-50 ft·lbs | 61-68 Nm |
Removal
1. See Figure 2-238. Remove retaining ring (1), clevis pin (2), footrest (3) and spring washer (4). Discard retaining ring.
![](https://motoinstruction.ru/img/harley/12/117855.jpg)
Figure 2-238. Passenger footrest assembly (optional on some models): 1. Retaining ring; 2. Clevis pin; 3. Footrest; 4. Spring washer; 5. Fastener (2); 6. Footrest support bracket; 7. Frame; 8. Clamp (left side only)
2. Remove two screws (5) and footrest support bracket (6) from frame (7).
Installation
Note. See Figure 2-238. Position clamp (8) between the left footrest support bracket (6) and the lower support bracket hole in the frame.
1. See Figure 2-238. Attach footrest support bracket (6) to frame (7) with two fasteners (5). Tighten to 45-50 ft·lbs (61-68 Nm).
2. Install footrest (3) on footrest support bracket with spring washer (4). Make sure spring washer is positioned inside support bracket mounting boss with the square edge toward the inside.
3. Align holes and push clevis pin (2) from top down through hole in support bracket. Secure with new retaining ring (1).
XR 1200X
FASTENER | TORQUE VALUE | |
Passenger footrest support bracket fastener: XR 1200X | 45-50 ft·lbs | 61-68 Nm |
Muffler bracket to footrest bracket screw: XR 1200X | 15-19 ft·lbs | 20.4-25.8 Nm |
Removal
1. See Figure 2-239. Remove retaining ring (4), clevis pin (2), footrest and spring washer (3). Discard retaining ring.
![](https://motoinstruction.ru/img/harley/12/117856.jpg)
Figure 2-239. Left and right passenger footrests: 1. Plug; 2. Clevis pin; 3. Spring washer; 4. Retaining ring; 5. Washer; 6. Fastener; 7. RH support; 8. LH support; 9. Heel rest; 10. Fastener
2. On right side of vehicle, remove screw securing muffler bracket to footrest support bracket.
3. Remove two fasteners (6), washers (5) and footrest support (7, 8) from frame.
Installation
1. See Figure 2-239. Attach left and right footrest support (7, 8) to frame with two fasteners (6) and washers (5). Tighten to 45-50 ft·lbs (61-68 Nm).
2. Attach muffler bracket to footrest support bracket with screw. Tighten to 15-19 ft·lbs (20.4-25.8 Nm).
3. Install footrests on footrest support with spring washer (3). Make sure spring washer is positioned inside support bracket mounting boss with the square edge toward the inside.
4. Align holes in footrest and support bracket and push clevis pin (2) from top down through hole in support bracket. Secure with new retaining ring (4).